Off-Line Profilometer SL

The Starrett-Bytewise ProfilometerSL was developed as an automated, non-contact measurement system to displace checking with hand tools. The ProfilometerSL is used to verify the accuracy of newly-cut dies by checking the extrusion dimensions. Its accuracy and speed helps reduce the number of die trials needed to approve a new die for production. Once in production, the ProfilometerSL is used to check each run for overall quality, and to monitor for die wear. The Starrett-Bytewise ProfilometerSL can help you improve your extrusion quality, reduce raw materials cost, and reduce extruder down-time for die trials.

Features
Specifications
Downloads



Contact Starrett

Features

  • Laser sensors provide accurate measurements on black rubber
  • The Thermal protection feature turns off sensors when the temperature reaches 45 degrees Celsius
  • The All-in-One Package makes the product more mobile and easier to transport
  • The Import Specifications feature imports XY break points from a data table
  • The Gauge Report feature specifies the measured thickness values at each breakpoint along with the design specification and error amount
  • The Point Report feature specifies the measured width values at each breakpoint along with the design specification and error amount
  • The Symmetry Report feature compares the right and left side point width, thickness, region area, and center of gravity
  • The Region Report feature analyzes area and center of gravity
  • The Conicity Report feature compares the area distribution of one side of the extruded component to the other providing an accurate comparison
  • Industrial PC can be ordered to your specifications

Specifications

  • Product Type: Off-Line Profilometer SL
  • Width Range: See Brochure
  • Width Accuracy: 0.30 mm
  • Width Repeatability (3s): 0.15 mm
  • Thickness Accuracy: 0.06 mm
  • Thickness Repeatability (3s): 0.02 mm
  • Area Accuracy: 0.025%
  • Area Repeatability (3s): 0.025%
  • Width Point Spacing: 0.15 mm
  • Cycle Time: 1 sec
  • Power at 220V: 10A
  • Laser Classification, CDRH: IIIA
  • Laser Classification IEC: 3R
  • Low Voltage Directive 73/23 EEG, 93/68/EEG: Yes
  • EMC Directive 89/336, 92/31/EEG, 93/68/EEG: Yes
  • EC Directive for Machinery 89/392/EEG: Yes

Downloads