 | 100% Data Collection –
Error-Free and Fast.
DataSure lets you perform real-time, 100% error-free data collection. The data can be collected and analyzed much faster than with manual inspection and data entry.
Manual Data Collection is Costly. If you are collecting inspection data manually, errors are inevitable. Hand writing or keying in data leads to mistakes that result in scrap, excess inventory – even parts rejected by your customers.
Hard-To-Ignore Savings.
The repetitive hand movements required to pick up tools, measure parts, put tools down, then record results is time consuming and error prone. With DataSure, you just measure and send.
The bottom line:
(time saved) x (your labor rate) + (savings from eliminated errors) = DataSure pays for itself over and over again. | |
|  For Most Tools with Output. DataSure works not only with Starrett electronic tools, but also Mitutoyo, Sylvac, CDI Tools, Mahr, Tesa and other brands. | | How DataSure Works
- DataSure End Nodes are attached to measuring tools throughout the shop
- After measuring, the operator presses a button on the End Nodes which transmits the data
- Data is transmitted to the nearest router, which transmits it to the Gateway and PC, or directly to the Gateway.
- The Gateway confirms receipt of the data by sending a signal back to the tool's End Node. Even if the main system is down or busy, up to ten readings can be stored in the End Node. | | Scalable from One Tool to an Entire Shop
DataSure is scalable from one tool with an End Node and Gateway to multi-tool systems spread over wide distances with several range-extending routers. |
|