b'The Slope tool is used to find modulus. MultipleThe Delta tool measures the differences between methods are available including automatic, chord,results.You can find creep by simply choosing this tangent, and best fit. tool and the two points you want to compare.Use the Min/Max/Avg tool to find maximum andYou can compare multiple graphs of your test runs and Use the Annotation tool tominimum values. It can also be used to calculatemeasure delta and variances between tests at precise add notes to any graph view. averages of all data between a segment you specify. points.Ideal for benchmark analysis.oftwareUse the Offset Yield Point tool to measure any data point onUse the Work tool to determine the energy orUsetheFormulaBuildertocreatecustom any of the three graph views.The point may be implicit orresilience from your stress-strain graph. expressionsandderivedresultsusing may be derived based on another result.For example, youalgebraic, trigonometric and logarithms.can find the point at 100mS before the point at 100% strain.SThe Peak/Valley tool is ideal for peel and coefficient ofFind break results based on a percentage friction testing.Measure the maximum, minimum, averagedrop or based on a load rate decrease.and counts of peaks and valleys.The Offset Yield Point tool is used to measure the yield strength at a 2% strain offset.Shown is modulus at 100% and 150% and the delta between these two measurements.starrett.com 39'