b'a utoMaticb uiLdero PtionStarrettLxsystemscanbeinterfacedwithancillaryinstrumentationfor factoryautomationapplicationsorwheremoreadvancedandcomplex measurements are necessary.The optional Automation Builder software packages can be used for interfacing with instrumentation and equipment through digital and analog I/O signals.oftwareS(Above) A conditional branching occurs when the Lmax result is out-of-tolerance.This will cause a message to display to the operator and it will cause a signal annunciator to light red for a failed test sample.The AutomationBuildercanalsobeusedtoincorporate conditional logic within your test setup.Conditional logic can be used to establish If/Else relationships, including the ability to automatically adjust test setup functionality basedDigital I/O can be used for contact closure testing.You can on events that occur during a test run.measure and determine the precise load that caused the "make" or "break" in an electronic component or switch. You may also use conditional logic combined with the digital outputs to light an annunciator based on a tolerance result, or control devices like rotary tables.58'