b'd iGitaLF orcec ontroLLerF or dvanced asic estinG PPLications dFc d iGitaLF orcec ontroLLera and b t aStarrett digital force gages can be used as handheld force gages forThe DFC is a revolutionary concept for force measurement using a basic applications or as a force sensor when used with a FMM Digitalhandheld force gage. The DFC may be used as a high-accuracy handheld Force Tester, MTL and MTH Manual Tester. Listed are the various testforce gage or as a digital controller for use with the FMM Digital Force methods that can be performed: Testers. The DFC can serve as a universal interface where you set up your tests and where you configure load limits, distance limits, breakLimit Testing - Use load, distance or a break condition andlimits, crosshead travel direction, crosshead speed and more. The DFC report results at the limit including maximum load and distancefeatures a measurement accuracy of 0.1% full scale with internal data at maximum load. sampling at 25kHz. Display resolution is 10,000:1. The DFC featuresLoad Average Testing - The load average test measures theBluetooth, USB and RS-232 communications plus digital I/O.load from the start and end of a test sequence.Time Average Testing - Set a time duration for a test. When oftwareload is measured at the start of the test, the test concludes at the end of the time duration. Average load is measured. Cyclic Count Testing - Define the number of cycles, up to 99,999 to be completed.SCyclic Duration Testing - Define the duration of cycles, up to 27 hours to becompleted. Constant Hold Testing - Hold at a distance or load for creep and relaxation results. The maximum duration is 27 hours. Contact Closure/Switch Testing - Uses the DFC force gage to signal when an electronic switch is opened or closed as load is applied or removed.Easy Test SetupAs a controller, the DFC can be used to measure load and control the FMM Test Frame. Create Load, Distance and Break Limit test methods in seconds.Comprehensive ResultsAt the completion of your test, the DFC will display load and distance results. These can be saved to memory or exported for reporting.60'