Pocket Calipers 1025, 1025ME St ainless Steel Pocket Slide Calipers INCH READING 5", 6"/INCH AND MILLIMETER READING 5"/130MM These handy tools permit quick, accurate outside and inside measurements. Their compact size fits easily in shop coat pockets. Calipers are made of fine quality stainless steel. • Readings are made directly from the two lines marked "in" and "out" on one side of the stock • Handy inch or millimeter scale on the back of the stock • Knurled thumb pieces to activate the slide and slide stop prevents tool from being disassembled • Knurled clamp screw with a left hand thread for easy one-hand operation • Straight measuring surface for outside measuring and rounded nibs for inside or hole measurements 424 St ainless Steel Pocket Slide Calipers 3-1/2" This extremely handy caliper gives direct readings of both circumference and diameter in a single setting. • Especially useful for obtaining instant circumference and diameter measurements of rope, cordage, metal rods, pipe, tubing, etc. and for checking cutting speeds on lathe work • 1-3/8" deep jaws will caliper a cylinder up to 2-3/4" diameter • The upper edge of the slide is graduated from 0 to 11 circumference inches in 16ths and the lower edge Cutting Speed in Feet per Minute = Circumference divided by 12 x Revolutions per Minute 1025-6 424 1025 Stainless Steel Pocket Slide Calipers Cat. No. EDP Size Range Depth of Jaws Width of Nibs Closed Graduations Outside Inside Slide Stock 1025-5 53123 5" 0-3-3/4" 1/4-4" 1-3/8" 1/4" 32nds and 64ths 32nds 1025-6 53124 6" 0-4-3/4" 1/4-5" 1-3/8" 1/4" 32nds and 64ths 32nds 1025ME Stainless Steel Pocket Slide Calipers Cat. No. EDP Size Range Depth of Jaws Width of Nibs Closed Graduations Outside Inside Slide Stock 1025ME-130 65860 5" (130mm) 0-3-3/4" (0-96mm) 1/4-4" (6–100mm) 1-3/8" or 36mm .236" or 6mm 64ths and 1/2mm mm Cases for 1025 and 1025ME Pocket Slide Calipers Cat. No. EDP Description 1025ZZ-5 55269 5" and 130mm Vinyl Case 1025ZZ-6 55270 6" Vinyl Case 424 Stainless Steel Pocket Slide Caliper and Circumference Gage Cat. No. EDP Size Range Graduations Depth of Jaws Dia. Circumference Dia. Circumference 424 51527 3-1/2" 0-3-1/2" 0-11" 32nds 16ths 1-3/8" 105 starrett.com S lide C alipers