267 Taper Gage 1/16 – 1-1/16" • Specially designed for rapid,accurate checking of inside diameters of tubing • Also very useful for general gaging of slot widths,hole sizes,setting calipers,etc. • Thin, tapered leaves graduated to measure inside diameters or widths from 1/16" to 1-1/16" in 64ths of an inch • Nicely finished spring-tempered steel,approximately 1" wide by 5-1/4" long Taper Gages These are named "taper" gages only because of their shape. They do not measure taper, but they do measure hole and slot sizes. They are quick to use, very accurate, and are a convenient size. Taper Gages 269, 269M Taper Gages .100-1"/2-25MM • These gages are for determining hole sizes in dies and all kinds of other work • Read in thousandths of an inch or 0.02mm • Made of tempered steel with a locking device for fixing any leaf in position for use 270 Taper Gage .010-.150"/0.3-4MM • Very useful tool, especially for bearing work and for gaging slots • Made of quality tool steel and accurately tapered throughout entire length for quick and convenient measuring • 7/16" (11mm) wide by 6-1/4" (160mm) long • Can be used as a precision shim • One side graduated from .010" to .150" in thousandths of an inch; the reverse side from 0.3mm to 4mm in one-twentieth of a mm (0.05mm) 267 Taper Gage Cat. No. EDP Description 267 51286 Taper Gage, 1/16 – 1-1/16" range 270 Taper Gage Cat. No. EDP Description 270 51292 Taper Gage, .010-.150" (0.3-4mm) range 269 Taper Gages - .001" Graduation Cat. No. EDP Range Length Leaves 269A 51290 .100-.500" 2-1/2" 8 269B 51291 .500-1" 2-3/4" 10 269M Taper Gages - 0.02mm Graduation Cat. No. EDP Range Length Leaves 269MA 56031 2-12mm 64mm 10 269MB 56032 12-25mm 70mm 13 267 270 269MA 323 starrett.com H ole G ages and S lot G ages